Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Dual unit installation wont maintain screen positions
#1
Has anyone had any issues , or can anyone offer a solution to an issue I am having with a dual GTN750 installlation. 

The units work as expected , and are displayed on RealsimGear GTN750 bezels, all hardware / buttons / touch screen work as expected. 

Unit 1 will not stay where I put it on screen, I can use the monitor settings at bottom of settings in the plugin, I can move it manually, I can maximise it, I can shrink it so it definitely is contained within the boundaries of the GTN 750 hardware screen. On restarting x-plane the display always starts on left hand side of montior 0 about 1/4 of the way up from the bottom. 

The saved rectangle co-ordinates appear sensible, although the height is alwaysa saved as 777 pixels and not 800. 

I have manually edited the .ini file to try and move it , no joy with that. I have also made the file read only to prevent changes being saved erroneoulsy by x-plane. 

X-Plane version 11.55 and latest TDS version. 

.ini file attached to this post, with a .txt extension as the website didn't seem to like .ini

Grateful for any suggestions.


Attached Files
.txt   TDSGTN.ini.txt (Size: 2.5 KB / Downloads: 1)
Reply


Messages In This Thread
Dual unit installation wont maintain screen positions - by Gary Spender - 09-24-2026, 01:54 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)